Fenix A320 Normal Checklist: Every Phase, Cold and Dark to Shutdown

By the SimTuts Team··21 min read·🇬🇧 English

Put this into practice: INIT Page Basics, free in your browser.

Quiz available: Take it below

Short answer: this is a phase-by-phase Fenix A320 checklist you can run alone, from a dark cockpit to a secured aircraft. Each phase is a table: read the left column as the challenge, check the right column as the response, then move on.

Print this: keep the page open on a second screen or tablet, or print just the phases you want beside you. It is written for one person doing both pilots' jobs, so items a real crew would split or cross-check are merged.

The order follows Airbus standard operating procedures as published in an A320-family FCOM, and the wording is our own. Airlines vary, so if your SOP differs, yours wins. Rows marked Fenix EFB happen on the tablet, not in the aircraft. This is for flight simulation only, never for real aircraft.

Preliminary Cockpit Preparation

Get power on and the IRS aligning before anything else. If there is no GPU, start the APU at the EXT PWR row using the Before Start steps.

ChallengeResponse
Fenix EFB: Ground ServicesChocks on, GPU connected
Engine mastersOFF
ENG MODE selectorNORM
Weather radarOFF
Gear leverDOWN
WipersOFF
Battery voltage (BAT switches off)Above 25.5 V on both
BAT 1 and BAT 2AUTO
EXT PWRON, once AVAIL shows
All three IR selectorsNAV
Fenix EFB: Mass and BalanceFuel and payload loaded
ECAM oxygen, hydraulic and oil levelsNormal
Flaps leverMatches the flaps shown on ECAM
Speedbrake leverRetracted, not armed
Brake accumulator pressureIn the green band
Parking brakeON

Cockpit Preparation

Work the overhead first, then the MCDU, then the glareshield. The narrated version of this phase explains each switch, and the INIT and F-PLN items here are the MCDU scenarios if you want to drill them.

ChallengeResponse
STROBE / BEACON / NAV & LOGOAUTO / OFF / ON
SEAT BELTS / EMER EXIT LTON once refuelled / ARM
PROBE/WINDOW HEATAUTO
LDG ELEV knobAUTO
PACK 1 and PACK 2ON - they wait for bleed air
X BLEED selectorAUTO
All fuel pumpsON, white OFF lights out
FUEL MODE SELAUTO
Engine and APU FIRE buttonsIn and guarded
A/SKID & N/W STRGON
Thrust leversIDLE
ATC and TCASSTBY
Radio panelsOn, COM frequencies tuned
MCDU INIT AFROM/TO, flight number, cost index, cruise level
MCDU F-PLNRoute, SID and STAR in, no unexplained discontinuity
MCDU RAD NAVChecked
MCDU INIT BZFW/ZFWCG and BLOCK FUEL match the EFB
MCDU PERFV1, VR, V2, FLX TO TEMP, THR RED/ACC, FLAPS/THS
Baro referenceQNH set on EFIS and standby
Both FDON
FCU speed windowDashed
FCU altitudeInitial expected altitude
IRS alignmentComplete, no flags on PFD or ND
Departure briefingDone, even if only out loud

Before Start

Confirm the numbers before you ask for push. Those MCDU checks are also the core of the A320 trainer.

ChallengeResponse
ZFW/ZFWCGStill match the final figures
Fuel on boardAgrees with the MCDU
Takeoff speeds and thrustPERF page matches the EFB calculator
APU MASTER SWON, wait 3 s
APU STARTON, wait for AVAIL
APU BLEEDON
EXT PWROFF
Fenix EFB: Ground ServicesGPU disconnected, chocks off
Doors and windowsClosed
Push and start clearanceObtained
BEACONON
ATCAUTO, squawk set
Brake accumulator pressureIn the green band
Parking brakeON, released for pushback

Engine Start

This follows the FCOM we used and FlyByWire's docs, which both start engine 1 first. Some airline SOPs start engine 2 first instead, and both orders get you running.

ChallengeResponse
Thrust leversIDLE - engines start whatever the lever position
ENG MODE selectorIGN/START
PacksNo action - they close by themselves for the start
ENG 1 MASTERON, wait for stable idle
ENG 2 MASTERON, wait for stable idle
ECAMNo engine cautions

After Start

Clean up the start, then configure for takeoff. If you are taxiing through rain, slush or snow in icing conditions, keep the flaps up until the holding point.

ChallengeResponse
ENG MODE selectorNORM
APU BLEEDOFF
Engine anti-iceON if OAT is at or below 10 °C with visible moisture
APU MASTER SWOFF, unless you still need it
Ground spoilersARMED
Rudder trimReset, reading zero
FlapsSet, and match PERF
Pitch trimSet for takeoff
ECAM STATUSChecked
Ground crewClear to disconnect

Taxi

Check the flight controls before or during the taxi, whichever suits. Radar and predictive windshear go on here, and the TCAS waits for the runway.

ChallengeResponse
Taxi clearanceObtained
NOSE lightTAXI
RWY TURN OFF lightsON
Parking brakeOFF, brake pressure zero
BrakesTested once rolling
Flight controlsFull travel, watched on ECAM F/CTL
F-PLNSID and transition match the clearance
FCU altitudeCleared altitude set
Both FDON
AUTO BRKMAX
Radar / PWSON / AUTO
ATCCode and mode set for takeoff
T.O CONFIG buttonPressed - T.O CONFIG NORMAL shown
T.O memoNo blue lines

Get flight sim tips in your inbox

New guides, checklists, and tips. No spam. Unsubscribe any time.

Before Takeoff

Delay the takeoff if the brakes are hot. Packs are your choice: off helps performance on a TOGA takeoff, on is fine otherwise.

ChallengeResponse
Brake temperatureBelow 300 °C, or 150 °C with brake fans on
Line-up clearanceObtained
TCASTA/RA
RunwayConfirmed correct
Approach pathClear of traffic
STROBEON
PacksAs required
Takeoff clearanceObtained
NOSE lightT.O
LAND lightsON

Takeoff and Climb

The levers go to the CL detent when LVR CLB flashes on the FMA, and then you leave them alone until landing. Flaps come in at the speeds marked on the PFD.

ChallengeResponse
ThrustPause near 50% N1 (1.05 EPR on IAE), then FLX or TOGA
100 ktSpeed confirmed on the PFD
VRRotate about 3° per second towards 15° pitch, then follow SRS
Positive climbGear UP
Thrust reduction altitudeLevers to CL
Packs, if offPACK 1 ON, then PACK 2 at least 10 s later
F speedFLAPS 1
S speedFLAPS 0
Ground spoilersDISARMED
NOSE and RWY TURN OFF lightsOFF
LAND lightsOFF and retracted by 10,000 ft
APU, if still runningBLEED OFF, MASTER OFF
Transition altitudeBaro STD, both sides

Cruise

This is the quiet phase, so use it to look for trouble early. Start the descent preparation well before the top of descent.

ChallengeResponse
ECAM memo and system pagesReviewed
Flight progress and fuelOn plan against F-PLN
Navigation accuracyMonitored
RadarAdjusted for weather
Step climbOnly when cleared

Descent

Do the preparation rows while still in the cruise. Below 10,000 ft you stay at 250 kt or less, which managed speed handles for you.

ChallengeResponse
Weather and landing informationObtained
Fenix EFB: landing performanceComputed for the runway
MCDU arrival and F-PLNSTAR, approach and missed approach checked
MCDU PERF APPRQNH, temperature, wind, minimum, landing flaps
MCDU RAD NAVApproach aids tuned
LDG ELEV knobAUTO
AUTO BRKLO or MED, by runway length and state
Arrival briefingDone
DES modeEngaged at top of descent
Transition levelBaro QNH, both sides
10,000 ftSEAT BELTS ON, LAND lights as required
ILS/LS buttonON for an ILS

Approach

Slow down in steps and never select the next flap setting above its VFE. The technique for flying the approach itself is in the ILS approach guide.

ChallengeResponse
APPR phaseActive - activate by hand if not in NAV
Green dot speedFLAPS 1
APPR button (ILS)Pressed, LOC and G/S armed
Glideslope capturedGo-around altitude set on FCU
About 2,000 ft AFEFLAPS 2, gear DOWN
Ground spoilersARMED
AUTO BRKConfirmed
NOSE / RWY TURN OFF / LANDT.O / ON / ON

Landing

Be on the path, in landing configuration and at VAPP by 1,000 ft above the airfield. If you are not, go around.

ChallengeResponse
FLAPS 3, then FULL if plannedSelected, not below 1,500 ft AFE
ECAM WHEEL pageThree green
A/THRSPEED mode or off
LDG memoNo blue lines
Autopilot, manual landingOFF
About 30 ftFlare, levers to idle (RETARD callout at 20 ft)
TouchdownReverse as planned, spoilers out
70 ktREV IDLE
Before 20 ktAutobrake off with the pedals
Taxi speedReversers stowed

Go-Around

Use this any time the approach or landing stops working. Thrust comes first, then the configuration.

ChallengeResponse
Thrust leversTOGA
RotationPitch up, follow SRS
FlapsRetract one step
Positive climbGear UP
Lateral modeNAV or HDG as required
Go-around altitudeSet and checked
Thrust reduction altitudeLevers to CL
Acceleration altitudeFlaps in at F and S speeds, spoilers disarmed

After Landing

Start this flow once you have vacated the runway. If you landed in icing conditions, leave the flaps out until after shutdown.

ChallengeResponse
Ground spoilersDISARMED
LAND lightsOFF or retracted
STROBEAUTO
NOSE lightTAXI
Radar / PWSOFF
ENG MODE selectorNORM
Flaps0
TCASSTBY
APUStarted, or start before shutdown

Parking

Confirm APU AVAIL before shutdown, or use EXT PWR if the APU is not available. Allow 3 min after high thrust, but idle reverse and taxi thrust do not count.

ChallengeResponse
Brake accumulator pressureIn the green band
Parking brakeON, brake pressure rising
Anti-iceOFF
APUAVAIL lit
APU BLEEDON
ENG 1 and ENG 2 MASTEROFF
SEAT BELTSOFF
BEACONOFF once the engines have spooled down
Fuel pumpsOFF
Fenix EFB: Ground ServicesChocks on, GPU connected if you want it

Securing

Run this when you are leaving the aircraft, not on a quick turnaround. The batteries go last.

ChallengeResponse
Parking brakeON
Crew oxygenOFF
FlapsRetracted
All three IR selectorsOFF, then wait 10 s before removing power
Exterior lightsOFF
APU BLEEDOFF
EXT PWROFF unless you want to keep it
APU MASTER SWOFF
EMER EXIT LT and signsOFF
BAT 1 and BAT 2OFF, about 2 min after AVAIL goes out

Where to Go Next

If one phase keeps catching you out, the fix is usually a dedicated guide rather than a longer checklist.

Test Your Knowledge

See how much you've learned from this guide with a quick 10-question quiz.

Put this into practice

Practise the exact MCDU procedures from this guide in your browser - free, no simulator needed.

Open the A320 MCDU Trainer

Learn the systems behind it: Airbus A320 Type Rating Knowledge →

Get flight sim tips in your inbox

New guides, checklists, and tips. No spam. Unsubscribe any time.