Short answer: this is a phase-by-phase Fenix A320 checklist you can run alone, from a dark cockpit to a secured aircraft. Each phase is a table: read the left column as the challenge, check the right column as the response, then move on.
Print this: keep the page open on a second screen or tablet, or print just the phases you want beside you. It is written for one person doing both pilots' jobs, so items a real crew would split or cross-check are merged.
The order follows Airbus standard operating procedures as published in an A320-family FCOM, and the wording is our own. Airlines vary, so if your SOP differs, yours wins. Rows marked Fenix EFB happen on the tablet, not in the aircraft. This is for flight simulation only, never for real aircraft.
Preliminary Cockpit Preparation
Get power on and the IRS aligning before anything else. If there is no GPU, start the APU at the EXT PWR row using the Before Start steps.
| Challenge | Response |
|---|---|
| Fenix EFB: Ground Services | Chocks on, GPU connected |
| Engine masters | OFF |
| ENG MODE selector | NORM |
| Weather radar | OFF |
| Gear lever | DOWN |
| Wipers | OFF |
| Battery voltage (BAT switches off) | Above 25.5 V on both |
| BAT 1 and BAT 2 | AUTO |
| EXT PWR | ON, once AVAIL shows |
| All three IR selectors | NAV |
| Fenix EFB: Mass and Balance | Fuel and payload loaded |
| ECAM oxygen, hydraulic and oil levels | Normal |
| Flaps lever | Matches the flaps shown on ECAM |
| Speedbrake lever | Retracted, not armed |
| Brake accumulator pressure | In the green band |
| Parking brake | ON |
Cockpit Preparation
Work the overhead first, then the MCDU, then the glareshield. The narrated version of this phase explains each switch, and the INIT and F-PLN items here are the MCDU scenarios if you want to drill them.
| Challenge | Response |
|---|---|
| STROBE / BEACON / NAV & LOGO | AUTO / OFF / ON |
| SEAT BELTS / EMER EXIT LT | ON once refuelled / ARM |
| PROBE/WINDOW HEAT | AUTO |
| LDG ELEV knob | AUTO |
| PACK 1 and PACK 2 | ON - they wait for bleed air |
| X BLEED selector | AUTO |
| All fuel pumps | ON, white OFF lights out |
| FUEL MODE SEL | AUTO |
| Engine and APU FIRE buttons | In and guarded |
| A/SKID & N/W STRG | ON |
| Thrust levers | IDLE |
| ATC and TCAS | STBY |
| Radio panels | On, COM frequencies tuned |
| MCDU INIT A | FROM/TO, flight number, cost index, cruise level |
| MCDU F-PLN | Route, SID and STAR in, no unexplained discontinuity |
| MCDU RAD NAV | Checked |
| MCDU INIT B | ZFW/ZFWCG and BLOCK FUEL match the EFB |
| MCDU PERF | V1, VR, V2, FLX TO TEMP, THR RED/ACC, FLAPS/THS |
| Baro reference | QNH set on EFIS and standby |
| Both FD | ON |
| FCU speed window | Dashed |
| FCU altitude | Initial expected altitude |
| IRS alignment | Complete, no flags on PFD or ND |
| Departure briefing | Done, even if only out loud |
Before Start
Confirm the numbers before you ask for push. Those MCDU checks are also the core of the A320 trainer.
| Challenge | Response |
|---|---|
| ZFW/ZFWCG | Still match the final figures |
| Fuel on board | Agrees with the MCDU |
| Takeoff speeds and thrust | PERF page matches the EFB calculator |
| APU MASTER SW | ON, wait 3 s |
| APU START | ON, wait for AVAIL |
| APU BLEED | ON |
| EXT PWR | OFF |
| Fenix EFB: Ground Services | GPU disconnected, chocks off |
| Doors and windows | Closed |
| Push and start clearance | Obtained |
| BEACON | ON |
| ATC | AUTO, squawk set |
| Brake accumulator pressure | In the green band |
| Parking brake | ON, released for pushback |
Engine Start
This follows the FCOM we used and FlyByWire's docs, which both start engine 1 first. Some airline SOPs start engine 2 first instead, and both orders get you running.
| Challenge | Response |
|---|---|
| Thrust levers | IDLE - engines start whatever the lever position |
| ENG MODE selector | IGN/START |
| Packs | No action - they close by themselves for the start |
| ENG 1 MASTER | ON, wait for stable idle |
| ENG 2 MASTER | ON, wait for stable idle |
| ECAM | No engine cautions |
After Start
Clean up the start, then configure for takeoff. If you are taxiing through rain, slush or snow in icing conditions, keep the flaps up until the holding point.
| Challenge | Response |
|---|---|
| ENG MODE selector | NORM |
| APU BLEED | OFF |
| Engine anti-ice | ON if OAT is at or below 10 °C with visible moisture |
| APU MASTER SW | OFF, unless you still need it |
| Ground spoilers | ARMED |
| Rudder trim | Reset, reading zero |
| Flaps | Set, and match PERF |
| Pitch trim | Set for takeoff |
| ECAM STATUS | Checked |
| Ground crew | Clear to disconnect |
Taxi
Check the flight controls before or during the taxi, whichever suits. Radar and predictive windshear go on here, and the TCAS waits for the runway.
| Challenge | Response |
|---|---|
| Taxi clearance | Obtained |
| NOSE light | TAXI |
| RWY TURN OFF lights | ON |
| Parking brake | OFF, brake pressure zero |
| Brakes | Tested once rolling |
| Flight controls | Full travel, watched on ECAM F/CTL |
| F-PLN | SID and transition match the clearance |
| FCU altitude | Cleared altitude set |
| Both FD | ON |
| AUTO BRK | MAX |
| Radar / PWS | ON / AUTO |
| ATC | Code and mode set for takeoff |
| T.O CONFIG button | Pressed - T.O CONFIG NORMAL shown |
| T.O memo | No blue lines |
Get flight sim tips in your inbox
New guides, checklists, and tips. No spam. Unsubscribe any time.
Before Takeoff
Delay the takeoff if the brakes are hot. Packs are your choice: off helps performance on a TOGA takeoff, on is fine otherwise.
| Challenge | Response |
|---|---|
| Brake temperature | Below 300 °C, or 150 °C with brake fans on |
| Line-up clearance | Obtained |
| TCAS | TA/RA |
| Runway | Confirmed correct |
| Approach path | Clear of traffic |
| STROBE | ON |
| Packs | As required |
| Takeoff clearance | Obtained |
| NOSE light | T.O |
| LAND lights | ON |
Takeoff and Climb
The levers go to the CL detent when LVR CLB flashes on the FMA, and then you leave them alone until landing. Flaps come in at the speeds marked on the PFD.
| Challenge | Response |
|---|---|
| Thrust | Pause near 50% N1 (1.05 EPR on IAE), then FLX or TOGA |
| 100 kt | Speed confirmed on the PFD |
| VR | Rotate about 3° per second towards 15° pitch, then follow SRS |
| Positive climb | Gear UP |
| Thrust reduction altitude | Levers to CL |
| Packs, if off | PACK 1 ON, then PACK 2 at least 10 s later |
| F speed | FLAPS 1 |
| S speed | FLAPS 0 |
| Ground spoilers | DISARMED |
| NOSE and RWY TURN OFF lights | OFF |
| LAND lights | OFF and retracted by 10,000 ft |
| APU, if still running | BLEED OFF, MASTER OFF |
| Transition altitude | Baro STD, both sides |
Cruise
This is the quiet phase, so use it to look for trouble early. Start the descent preparation well before the top of descent.
| Challenge | Response |
|---|---|
| ECAM memo and system pages | Reviewed |
| Flight progress and fuel | On plan against F-PLN |
| Navigation accuracy | Monitored |
| Radar | Adjusted for weather |
| Step climb | Only when cleared |
Descent
Do the preparation rows while still in the cruise. Below 10,000 ft you stay at 250 kt or less, which managed speed handles for you.
| Challenge | Response |
|---|---|
| Weather and landing information | Obtained |
| Fenix EFB: landing performance | Computed for the runway |
| MCDU arrival and F-PLN | STAR, approach and missed approach checked |
| MCDU PERF APPR | QNH, temperature, wind, minimum, landing flaps |
| MCDU RAD NAV | Approach aids tuned |
| LDG ELEV knob | AUTO |
| AUTO BRK | LO or MED, by runway length and state |
| Arrival briefing | Done |
| DES mode | Engaged at top of descent |
| Transition level | Baro QNH, both sides |
| 10,000 ft | SEAT BELTS ON, LAND lights as required |
| ILS/LS button | ON for an ILS |
Approach
Slow down in steps and never select the next flap setting above its VFE. The technique for flying the approach itself is in the ILS approach guide.
| Challenge | Response |
|---|---|
| APPR phase | Active - activate by hand if not in NAV |
| Green dot speed | FLAPS 1 |
| APPR button (ILS) | Pressed, LOC and G/S armed |
| Glideslope captured | Go-around altitude set on FCU |
| About 2,000 ft AFE | FLAPS 2, gear DOWN |
| Ground spoilers | ARMED |
| AUTO BRK | Confirmed |
| NOSE / RWY TURN OFF / LAND | T.O / ON / ON |
Landing
Be on the path, in landing configuration and at VAPP by 1,000 ft above the airfield. If you are not, go around.
| Challenge | Response |
|---|---|
| FLAPS 3, then FULL if planned | Selected, not below 1,500 ft AFE |
| ECAM WHEEL page | Three green |
| A/THR | SPEED mode or off |
| LDG memo | No blue lines |
| Autopilot, manual landing | OFF |
| About 30 ft | Flare, levers to idle (RETARD callout at 20 ft) |
| Touchdown | Reverse as planned, spoilers out |
| 70 kt | REV IDLE |
| Before 20 kt | Autobrake off with the pedals |
| Taxi speed | Reversers stowed |
Go-Around
Use this any time the approach or landing stops working. Thrust comes first, then the configuration.
| Challenge | Response |
|---|---|
| Thrust levers | TOGA |
| Rotation | Pitch up, follow SRS |
| Flaps | Retract one step |
| Positive climb | Gear UP |
| Lateral mode | NAV or HDG as required |
| Go-around altitude | Set and checked |
| Thrust reduction altitude | Levers to CL |
| Acceleration altitude | Flaps in at F and S speeds, spoilers disarmed |
After Landing
Start this flow once you have vacated the runway. If you landed in icing conditions, leave the flaps out until after shutdown.
| Challenge | Response |
|---|---|
| Ground spoilers | DISARMED |
| LAND lights | OFF or retracted |
| STROBE | AUTO |
| NOSE light | TAXI |
| Radar / PWS | OFF |
| ENG MODE selector | NORM |
| Flaps | 0 |
| TCAS | STBY |
| APU | Started, or start before shutdown |
Parking
Confirm APU AVAIL before shutdown, or use EXT PWR if the APU is not available. Allow 3 min after high thrust, but idle reverse and taxi thrust do not count.
| Challenge | Response |
|---|---|
| Brake accumulator pressure | In the green band |
| Parking brake | ON, brake pressure rising |
| Anti-ice | OFF |
| APU | AVAIL lit |
| APU BLEED | ON |
| ENG 1 and ENG 2 MASTER | OFF |
| SEAT BELTS | OFF |
| BEACON | OFF once the engines have spooled down |
| Fuel pumps | OFF |
| Fenix EFB: Ground Services | Chocks on, GPU connected if you want it |
Securing
Run this when you are leaving the aircraft, not on a quick turnaround. The batteries go last.
| Challenge | Response |
|---|---|
| Parking brake | ON |
| Crew oxygen | OFF |
| Flaps | Retracted |
| All three IR selectors | OFF, then wait 10 s before removing power |
| Exterior lights | OFF |
| APU BLEED | OFF |
| EXT PWR | OFF unless you want to keep it |
| APU MASTER SW | OFF |
| EMER EXIT LT and signs | OFF |
| BAT 1 and BAT 2 | OFF, about 2 min after AVAIL goes out |
Where to Go Next
If one phase keeps catching you out, the fix is usually a dedicated guide rather than a longer checklist.
- A320 MCDU explained for the pages behind the Cockpit Preparation rows.
- A320 managed descent guide for the Descent phase.
- Fenix A320 failure training guide for when the normal checklist stops being enough.



