Route Amendments Ahead: NEXT WPT
PremiumintermediateATC changes your route after a fix you have not reached yet. DIR TO is the wrong tool for that, because it starts from where you are now. Use the lateral revision's NEXT WPT to take a shortcut at a fix ahead, then to accept a reroute that leaves a discontinuity you must close yourself.
ATC changes your route after a fix you have not reached yet. DIR TO is the wrong tool for that, because it starts from where you are now. Use the lateral revision's NEXT WPT to take a shortcut at a fix ahead, then to accept a reroute that leaves a discontinuity you must close yourself.
Fly this one with Premium
The MCDU checks every entry as you make it, and tells you when an entry was accepted but wrong.
Step-by-step: Route Amendments Ahead: NEXT WPT
- Set the route. Type KLAS/KDEN into the scratchpad and press 1R.
Las Vegas to Denver is 545 nm great-circle, a little over two hours. You will also see 628 quoted, which is statute miles. Long enough for ATC to change the route more than once, which is what this flight is about.
- Set the cruise level. Type 350 and press 6L.
FL350 is an odd level, so it suits an eastbound flight. Nothing later turns on the level; the FMGS simply wants one before the plan means much to it.
- Open the flight plan. Press F-PLN.
The plan reads KLAS, a discontinuity, KDEN: the skeleton FROM/TO builds. The filed route joins jet route J60 at BLD, the Boulder City VORTAC about 15 nm east-southeast of the airport, and you will build that first.
- Put BLD into the plan. Type BLD and press 2L, the DISCONTINUITY line. BLD takes the line and the discontinuity moves down below it, so clear it: press CLR, then 3L.
A waypoint typed straight onto the flight plan goes into the active plan at once, with no temporary plan to review, and the FMGS puts a discontinuity after it rather than assume the next fix joins on. CLR is how you tell it that it does. Keep that in mind: in a moment you will do a similar job through a lateral revision instead, and the difference is the point of this scenario.
- Open the lateral revision at BLD. Press the LEFT key beside BLD, 2L.
Every lateral revision starts here, and the waypoint you open it on is the waypoint the change is made AFTER. Look at the page while you are on it: NEXT WPT sits at 3R with empty brackets. That is the tool for later in this flight.
- Add the airway. Press 5R (AIRWAYS>), type J60 and press 1L, type DVV and press 1R, then press 6R to INSERT.
J60 from Boulder City runs Bryce Canyon (BCE), Hanksville (HVE), Red Table (DBL) and Mile High (DVV), and INSERT strings exactly that stretch into the plan. Read it on the way back: KLAS, BLD, BCE, HVE, DBL, DVV, KDEN, with no gaps. That is your cleared route, and it is the plan you are about to change twice.
- You are airborne, climbing towards BCE. Center: "After Bryce Canyon, cleared direct Red Table." Open the lateral revision at BCE: press the LEFT key beside it, 3L.
Listen to where the clearance starts. You are still to fly to BCE as planned; only what happens AFTER it changes. DIR TO would be the wrong tool here, because a direct-to starts from present position: it would cut BCE out and turn you now. The revision belongs to BCE, so you open LAT REV at BCE.
- Type DBL and press 3R, NEXT WPT.
DBL was already further down the plan, so making it the next waypoint after BCE removes everything in between: HVE has gone, and the plan reads BCE, DBL, DVV with no discontinuity. One difference from the aircraft, said plainly. On the A320 a NEXT WPT entry builds a temporary flight plan, drawn in yellow, and the active plan does not change until you press INSERT at 6R. That review is the reason the revision exists: the FCOM contrasts it with typing onto F-PLN, which goes straight in. This trainer has no temporary plan, so the change goes in as you press 3R and you land on F-PLN. Do the check you would do on the yellow version: BCE, then DBL, and HVE gone.
- Before you reach BCE, storms build over the route. Center: "After Bryce Canyon, proceed direct Meeker, then direct Red Table." Open LAT REV at BCE again (3L), type EKR and press 3R.
This time the fix is new to the plan, and the FMGS treats a new waypoint differently. It goes in after BCE, and a discontinuity goes in after it, before DBL. The FMGS does not know how you rejoin the old route from Meeker, so it will not guess. The plan now reads BCE, EKR, a discontinuity, DBL. On the aircraft that is the yellow plan you would be looking at before INSERT, and the gap in it is the question the FCOM leaves to you: clear the discontinuity "as appropriate".
- The clearance says "then direct Red Table", so the gap should close onto DBL. Press CLR, then 5L, the discontinuity line.
The plan reads BCE, EKR, DBL, DVV, KDEN, one continuous route that matches the clearance word for word. That match is the check: close a discontinuity only when the clearance tells you how the two sides join, because closing it is you telling the FMGS to fly that leg. Had ATC said "then direct Mile High" instead, the right answer would have been a NEXT WPT of DVV at EKR, not a CLR. Last habit worth banking: after any route change, read the plan from the aircraft to the destination before you trust it.
The rest of Enroute Operations
Step Climb Mid-Cruise
PremiumadvancedMid-Atlantic at FL340, hours of fuel burnt off, and the aircraft can now fly higher and cheaper. Check the maximum, then step up.
๐ EGLL โ KJFKโฑ ~5 min๐ 5 stepsATC Shortcut: Going Direct
Premiumintermediate"Direct OCK" - five seconds of radio and a chunk of your flight plan gone. On this FMS the keypress is the commitment: there is nothing to confirm and nothing to undo.
๐ EGLL approach - direct routingโฑ ~4 min๐ 6 stepsDiversion to Alternate
PremiumintermediateMid-planning, ATC sends you to Brussels instead of Paris. Rebuild the flight around a new destination without unpicking the whole thing.
๐ EGLL โ LFPG, then divert to EGLL โ EBBRโฑ ~4 min๐ 8 stepsSpeed & Altitude Constraints (VERT REV)
PremiumintermediateATC wants you at an altitude by a waypoint. The vertical revision page is where that promise gets written into the flight plan.
๐ EGLL โ MID โ LFPGโฑ ~4 min๐ 5 stepsEntering a Holding Pattern (HOLD)
PremiumintermediateHolding is not a manoeuvre you fly from memory on an airliner - you build it in the box. Here is where the HOLD page hides and what it wants.
๐ HOLD AT LFPGโฑ ~4 min๐ 6 steps
Background reading
- GuideThe A320 MCDU Explained: Every Page, Simply
What is the A320 MCDU? A plain-English guide to every Airbus MCDU page - INIT, F-PLN, PERF, RAD NAV and more. Practice free in our MCDU trainer.
- GuideFenix A320 Normal Checklist: Every Phase, Cold and Dark to Shutdown
A printable Fenix A320 checklist for MSFS: every phase from cold and dark to securing the aircraft, in challenge and response form for one pilot.
- GuideiniBuilds A320 V2 in MSFS 2024: Complete Flight Tutorial
Complete iniBuilds A320 V2 tutorial for MSFS 2024 - FCU push/pull, managed vs selected modes, MCDU programming, and takeoff to landing.